Network Cisco WLC¶
The nep-network-cisco-wlc provides the minimum requirements to implement a basic monitoring of a Cisco WLC using SNMP protocol.
Using the provided objects, is possible to:
Perform check on Access Point Status
Perform check on Access Point List
Perform check on Count Access Point Clients
Minimum supported environment¶
This package can be installed on systems running the software described below. Systems with equivalent components are also suitable for installation.
Required software |
Requirements |
|---|---|
NetEye |
Version |
NetEye modules |
|
Package requirements¶
Service and Host Template shipped with package nep-network-cisco-wlc require the following nep:
nep-common
nep-network-base
Setup instructions¶
If all requirements are met, you can now install this package. To manually set up the nep-common package, just use nep-setup utility to install it.
nep-setup install nep-common
Once installed the following custom variables should be set:
nx_hardware_vendor = Cisco
Available Objects¶
This section contains a description of all the Objects from this package that can be used to build your own monitoring environment.
Director Objects¶
This package contains the following Director Objects:
Service Sets
The following Service Sets can be used to freely monitor Host Objects. Remember to not edit these Service Sets because they will be restored/updated at the next NEP Package update.
Service Set name |
Description |
|---|---|
nx-ss-network-cisco-wlc |
Service Set providing monitoring for Cisco WLC |
ITOA Dashboards¶
The Package does not provide any ITOA Dashboards right now.
Package’s objects list¶
Object Type |
Object Name |
Editable |
Containing File |
|---|---|---|---|
Director Service Set |
nx-ss-network-cisco-wlc |
No |
baskets/import/nep-network-cisco-wlc-05-serviceset.json |
