Network Cisco WLC¶
nep-network-cisco-wlc provides the minimum requirements to implement a basic monitoring of a Cisco WLC using SNMP protocol.
Using the provided objects, is possible to:
Perform check on Access Point Status
Perform check on Access Point List
Perform check on Count Access Point Clients
Minimum supported environment¶
This package can be installed on systems running the software described below. Systems with equivalent components are also suitable for installation.
Service and Host Template shipped with package
nep-network-cisco-wlc require the following nep:
If all requirements are met, you can now install this package. To manually set up the
nep-common package, just use
nep-setup utility to install it.
nep-setup install nep-common
Once installed the following custom variables should be set:
nx_hardware_vendor = Cisco
This section contains a description of all the Objects from this package that can be used to build your own monitoring environment.
This package contains the following Director Objects:
The following Service Sets can be used to freely monitor Host Objects. Remember to not edit these Service Sets because they will be restored/updated at the next NEP Package update.
Service Set name
Service Set providing monitoring for Cisco WLC
The Package does not provide any ITOA Dashboards right now.
Package’s objects list¶
Director Service Set