User Guide

Network Cisco WLC

The nep-network-cisco-wlc provides the minimum requirements to implement a basic monitoring of a Cisco WLC using SNMP protocol.

Using the provided objects, is possible to:

  • Perform check on Access Point Status

  • Perform check on Access Point List

  • Perform check on Count Access Point Clients

Minimum supported environment

This package can be installed on systems running the software described below. Systems with equivalent components are also suitable for installation.

Required software

Requirements

NetEye

Version 4.20+

NetEye modules

Core

Package requirements

Service and Host Template shipped with package nep-network-cisco-wlc require the following nep:

  • nep-common

  • nep-network-base

Setup instructions

If all requirements are met, you can now install this package. To manually set up the nep-common package, just use nep-setup utility to install it.

nep-setup install nep-common

Once installed the following custom variables should be set:

  • nx_hardware_vendor = Cisco

Available Objects

This section contains a description of all the Objects from this package that can be used to build your own monitoring environment.

Director Objects

This package contains the following Director Objects:

Service Sets

The following Service Sets can be used to freely monitor Host Objects. Remember to not edit these Service Sets because they will be restored/updated at the next NEP Package update.

Service Set name

Description

nx-ss-network-cisco-wlc

Service Set providing monitoring for Cisco WLC

ITOA Dashboards

The Package does not provide any ITOA Dashboards right now.

Package’s objects list

Object Type

Object Name

Editable

Containing File

Director Service Set

nx-ss-network-cisco-wlc

No

baskets/import/nep-network-cisco-wlc-05-serviceset.json